Card has been to two days, after two days of use, has basically been a bit of data, you can refer to together! Let's start with the appearance.
Look out of the box can go here
The positive appearance of the RX480 Platinum uses black and white, and is based on black. The reason is not to know why the official picture was taken out of the metal texture. In fact, it is a large piece of plastic. Although it is still good, the overall style continues the previous generation of ultra-platinum style. The ancestral gas stove!
side:
Power supply is 8PIN, the side of the heatsink exposed bare heat effectively, the main outlet.
Sapphire LOGO light on the side of the video card, with 6 lighting modes
Default Blu-ray
Rainbow effect
According to the temperature shows different amount of light, full load is red
Almost as above, controlled by fan speed
Closed, this is not a light
Customized by the user, although I will not get this
A total of five interfaces, 1.DVI-D, 2.DisplayPot1.4 2HDIM different from the original card This card does not support simple DVI to vga adapter, direct use of DVI-D, if your monitor is still VGA, then please buy with signal conversion!
Red light switch button, zoom in to see a small black switch, is to switch dual BIOS
Read the online dismantling, this thick thermal version, also suppressed the memory
Tested below
This is my configuration, last year's mainstream configuration
GPU-Z
You can see the core 1342MHZ memory 2000MHZ. 2304 stream processors, it is said that there is still a part of the audio, unfortunately. 256BIT memory bandwidth, with GDDR5, 8G memory, it is estimated that the next generation of cards will be on HBM2, support DX12
Power consumption test is not good under the table!
Standby
Fully loaded around 320W 
This is the overall power consumption, the above configuration can not see, I have 2 mechanical hard drives
Temperature test,
Standby is actually good,
40-45 degrees
Full use, because I am a small chassis, there is only a rear window fan, the temperature is 80 to 89 degrees, so the air duct is not recommended to this card
Running sub-tools:
Master Lu
3D Mark
FS
FSE 
4K
TS DX12 benchmark
Steam VR
Game Test Resolution 1920X1080
GTA5
Just try to play, there are many cutscenes, anti-aliasing open to 8 probably in more than 40 frames, turn off anti-aliasing more than 100 to more than 70! Very process color is also beautiful! Forget the screenshot, leave this
Tomb Raider 10
Can be full effect, picture quality is quite good, this time the screenshot is not showing the number of frames under DX12
All of them are just playing, and many of the cutscenes are taught. They don't feel stuck. This average number of frames shouldn't be too much. Because they're not professional evaluation games, they're bought both.
At the end, you value friends, this card needs to pay attention to a few points, the first length, the official data is 24CM, but you do not think that iu chassis has a 25CM26CM is enough, at least 27, because the power supply in the tail, then select this card , can not choose the front there is no air intake, I use it down, this card two-thirds of the heat is discharged from the tail of ah, like my small chassis temperature is a bit too high!
Well, after fulfilling what I said in a box of drying materials, this evaluation has come to an end. I did not expect that the forum post will be so full. Thank you